For professional, multi step testing of voltage and polarity with LED display.
With 7 LED indications: 6V, 12V, 24V, 50V, 120V, 220V and 400V AC/DC.
Force 88408 Voltage tester features:
The voltages indicated are nominal values
The display of the excessing of the upper limited value for low voltages only serves as a warning for the user and it is not a measured value
Suitable for AC (altenate current) and DC (direct current) voltages, from 6 to 400 Volts
Read the safety instructions before use.
- FORCE UNIVERSAL VOLTAGE DETECTOR Prior to using the Unlversal voltage Detector be Bure to read the following instruction for operation
- 1 The voltages indicated on the universal voltage delector are nominal values
- 2.Be use the the Universal voltage in Systems, appliances and devices within the area nominalvoltaof6 to 400 V faltamating current and direct current)
- 3 For testing only grasp the handles of the Univer al vollage detector shown in the figure 1) and sure not louch the testing electrodes The voltage can be detected only via double-pole
- 4 whether theapparatus isfree from any voltage, make sure to safety voltage detector is properly functioning (DIN VDE 0105 To lost the functionality of the safety voltage you may check th for mple connecting it a well-functioning power socket, ifone or more d displays or cannotbe indicated,do no longeruse the the voltage detector
- 5 Always keep the Universal voltage detector in a clean and dry place
- 6 Do allow a disassembly the Universal voltage detector by unauthorized persons
- 7 For a proper display keep the device within a temperature range of 10 C to 50 C
- 8 the safety voltage detector cannot be left switched on for more than 30 seconds.The pause following it should not be longer than 240sec
- 9The light-emitting diode (LED) indicated with the symbol and indicate the applied polarity on the indicating handle, if the direct current is higher than 6 V if both LED diodes are lighting up at the same time, the device uses alternating current.Incase of higher voltages, all voltage indicating LED diodes are lighting up at the same time
- 10.The light-emitting diodes are indicating the effective voltages between the voltage peaks Within the respective nominal voltage range, the light-emitting diodes starting lighting up,ofthe nominal voltage is higher than B5%
- 11 There will be no display when the neutral conductor (N) orthe protective conductor (PE) is interrupted
- 12 not use the Universal voltage detector during rainy weather
- 13 The display of the excessing of the upper limitedvalue for low voll (ELV) only serves as for a warning for the user, and is not ao a measured value.Figure 1 SPECIFICATIONS voltage range ning Volage: 6-400V
